The chimney top housings described here make possible many different arrangements of fireplace and chimney flues terminating in the same "double" housing or in separate housings (See diagram of arrangements on opposite page). Each housing is available in simulated brick finish of off-white, red or sun-tan color, baked on in modern ovens for permanence. Add the letter "W". "R", or "T" respectively to model numbers below for color desired. All housings are 54" high.
STANDARD T-l HOUSING
The standard square housing is 18" x 18" and is used for separate fireplace and furnace flue installations, or where it is not feasible to locate both chimneys together.
DELUXE T-2 HOUSING
This 18" x 36" deluxe rectangular housing is used where the furnace chimney is located directly in back of the fireplace chimney. It can also be used for double Thulman Fireplace installations—one below the other or back-to-back—or to house a single fireplace chimney and create a more massive appearance. Centerline of two chimneys should be located 18" apart.
DELUXE T-4 HOUSING
A really massive chimney. 18" x 54", usable in place of any of the other top housings but offering greater leeway in that the distance between chimney center-lines is 36".
DELUXE T-101 HOUSING
For a more massive appearance, this 18" x 27" rectangular housing for a single chimney is used in place of the standard T-l housing.
DELUXE T-3 HOUSING
This is an 18" x45" deluxe rectangular housing and can be used in any installation where the T-l. T-101. or T-2 might apply, for a massive appearance with only one chimney or with two chimneys 27" apart on their centerlines. It can be used where a furnace chimney must pass up on either side of the fireplace casing.
DELUXE TOP HOUSINGS
May be installed so the long dimension is parallel with, or at right angles to. the roof ridge. Stated distances between flue centerlines must be maintained, if used for both furnace and fireplace chimneys. The diagrams on opposite page show possible arrangements.
